How to setup a new quad with a single click using auto applied snippets

In this tutorial, we'll take a look at how to use Dronesitter's snippets feature create a set of custom snippets and auto apply it to a new quad.

1
After landing on Dronesitter's dashboard, click on the "PIDs/Rates/Configs" button on the top right corner
Entry button for Dronesitter stock pids modal.
2
You should see a dialog like this, click on the "Private" tab
Dronesitter stock pids/rates/configurations modal.
3
Click on the big "Create" button
Dronesitter 'Create snippet' button.
4
In the dialog, put in your configuration snippets. Any valid CLI command works. In this case, I put in the configs of ExpressLRS receiver. Tick the "Auto apply" checkbox.
Dronesitter 'New snippet' modal.
5
Using the same method, create another snippet for your favorite rates.
Dronesitter 'New snippet' modal.
6
Close the dialog and connect to a quad using the "Connect Quad" button. (You can find out how in the 2 minute walk-through here:  how to sync betaflight/inav configurations) Once connected, you can see the snippets you just created shown in the "Pending configurations" row with an "Apply all" button on the side. Click it to apply all the pending snippets.
Apply Dronesitter stock pids/rates/configurations.

The next time you set up a new quad, Dronesitter will know that no auto snippets has been applied yet and you can apply all the common configurations like OSD/receiver/rates/PIDs with a single click.